416-745-9191
|
||
|
Heaters
Heater 1,500 watt
• Thermostat controlled.
• Three heat setting tip-over switch.
• 6' cord.
• Electric.
• 110 volts.
Heater 2,000 – 5000 Watt
• Ideal for garages and workshops.
• Fan is propeller type accurately balanced and correctly
pitched to optimize performance.
• Electric.
• 240 volts.
• 6' cord.
Heater 9,000 watt
• A high-performance construction heater for heating
large areas.
• Plugs into 240 volts.
• Electric.
• 40 amp outlet.
Double Tank Connectors
• Used for manifolding up to three propane cylinders.
Hand Torch Vapour
• Used to thaw out frozen pipes.
• 30,000 - 500,000 BTU.
Hand Torch Liquid
• Used for roofing repairs.
• 1,000,000 - 2,000,000 BTU.
Heater 10,000 BTU Trailer
• Natural gas.
• Used to heat shops and garages where natural gas
is available.
Heater 15,000 BTU Radiant
• Ideal for heating small areas.
• Propane powered.
Heater 30,000 BTU Radiant
• No electricity required.
• Operates on standard 20lbs cylinder.
• Tip-over switch and safety shut-off.
• Propane powered.
• Heats up to 800 sq. ft.
Heater 60,000 BTU Radiant
• Double burner.
• No electricity required.
• Operates on a standard 40lbs cylinder.
• Propane powered.
Heater 120,000 BTU Radiant
• Natural gas or propane.
• Rugged, durable: to be used on construction sites.
• No electricity required.
• Heats up to 3000 sq. ft.
Heater 150,000 BTU Radiant
• Used for heating construction sites and tarped-in
scaffolding when brick laying.
• Propane powered salamander.
Heater 360,000 BTU Radiant
• Electricity required to operate the fan, used to circulate heat.
• Propane powered salamander.
Heater 400,000 BTU (Propane / Natural Gas)
• Great dual-fuel units.
• Run it on propane until the natural gas lines are in and
then flip the switch.
• Used on construction sites.
• Electricity required.
• Thermostat control.
Heater 400,000 BTU (Indirect Propane / Natural Gas)
• These units can be used as a portable furnace.
• Used on construction sites, thermostat controlled.
• Operates on 120 volts.
Heater 1,000,000 BTU (Propane / Natural Gas)
• Large units that will change over from propane fuel to
natural gas.
• Electric spark ignition safety protection air sensing switch.
Heater 1,500,000 BTU (Propane / Natural Gas)
• Thermostat controlled, high-low off flame provides more
consistent even temperature plus less gas consumption.
• Large units that will change over from propane fuel to
natural gas.
Heater 2,000,000 BTU (Propane / Natural Gas)
• Large volume heater.
• Able to run on propane fuel or natural gas.
• Thermostat controlled.
• Power requires at least 240 volts.
Regulator
Regulator ¾” – 2”
• Propane or natural gas.
Cylinder Lift Basket
• Great for moving cylinders around at job sites.
• Lifting hook to attach to crane.
• For outdoor use.
• Propane powered.
• Manual ignition.
• Uses a standard 20lbs propane cylinder.
• 46,000 BTU.
• Used for drying wet carpet.
• Displacement of 3000cfm.
• Two speed fan.
• Great for drying basement.
• Could be run in series.
Pedestal Fan 30”
• Used for circulating air.
• Two speed fan.
• Extracts fumes, dusts or moves air to where it is required.
Air Mover 20”
• These units move a large volume of air.
• Normal 110V.
• Distributes heat and maintains air exchange on construction
site.
Air Mover 30”
• Large volume air mover.
• These units have casters on the bottom to roll around easily.
• Normal 110V power.
Air Mover 42”
• Powerful, large volume air mover.
• Normal 110V power.
• These units have casters to roll around easily.
• Used to ventilate a very large area.
Exhaust Fan
Exhaust Fan 12”
• Used to ventilate manholes for worker comfort and safety.
• Moves fresh air to workers in confined areas.
Duct
Duct 12” X 25”
• For exhaust fan.
• Our duct hoses are made of flexible, light duty vinyl woven
polyester.
|
|